Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2011JOURNEY R/T, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 6 (2.4L - PCM/TCM PROGRAMMING, INTERMITTENT CONDITION, PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE & PCM VERIFICATION TEST)STANDARD PROCEDUREPCM / TCM PROGRAMMINGSECTION 2 - ADDITIONAL PCM / TCM REPLACEMENT PROCEDURESIF AN EDC16-CP31-2 (2.8L) WAS REPLACED, PERFORM THE FOLLOWING ADDITIONAL STEPS AND/OR ROUTINES
2011 Dodge and Ram Journey R/T, AWD
If an EDC16-CP31-2 (2.8L) was replaced, perform the following additional steps and/or routines
2011 Dodge and Ram Journey R/T, AWDSECTION If an EDC16-CP31-2 (2.8L) was replaced, perform the following additional steps and/or routines
WARNING: This page is about a different variant/trim than selected.
- PCM/ECM Replaced - if WIN equipped
- Check PCM/ECM VIN - if NOT WIN equipped
- Injector Quantity Adjustment
- Program Variant Code
- ECU Replacement With Value Transfer - if the ECU to be replaced is still responsive
- ECU Replacement Without Value Transfer - if the ECU to be replaced is NOT responsive
- Fuel Mean Value Adaptation Initialization
- IMA Rapid Calibration Test
- Set Oil Dilution Mass Value
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.