Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSDODGE AND RAM2011JOURNEY R/T, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL SYSTEMFUEL INJECTION, GASSENSOR, MANIFOLD AIR PRESSURE (MAP)REMOVAL2.4L

2011 Dodge and Ram Journey R/T, AWD

Sensor, Manifold Air Pressure (Map): Removal: 2.4L

2011 Dodge and Ram Journey R/T, AWDSECTION 2.4L

Fig 1: MAP Sensor Location

GC0082499

Courtesy of CHRYSLER LLC

Disconnect and isolate negative battery cable.
Disconnect electrical connector from manifold absolute pressure (MAP) sensor.
Remove screw from MAP sensor.

Fig 2: MAP Sensor
Courtesy of CHRYSLER LLC
Remove MAP sensor.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.