Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2011JOURNEY R/T, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL SYSTEMFUEL DELIVERY, GASSTANDARD PROCEDUREFUEL SYSTEM PRESSURE RELEASE PROCEDURE
2011 Dodge and Ram Journey R/T, AWD
Fuel System Pressure Release Procedure
2011 Dodge and Ram Journey R/T, AWDSECTION Fuel System Pressure Release Procedure
- Remove fuel fill cap.
- Remove fuel pump fuse from Totally Integrated Power Module (TIPM). For location of fuse, refer to label on underside of TIPM cover.
- Start and run engine until it stalls.
- Attempt restarting engine until it will no longer run.
- Turn ignition key to OFF position.
- Place a rag or towel below fuel line quick-connect fitting at fuel rail.
- Disconnect quick-connect fitting at fuel rail. Refer to STANDARD PROCEDURE .
- When the repair is complete, reconnect fuel fittings and return fuel pump fuse to TIPM.
- One or more Diagnostic Trouble Codes (DTC's) may have been stored in PCM memory due to fuel pump fuse removal. A diagnostic scan tool must be used to erase a DTC.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.