Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2011JOURNEY R/T, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTRADIO FREQUENCY MODULE (RF HUB) - ELECTRICAL DIAGNOSTICSDTC TROUBLESHOOTINGB1A0B-00-RKE FOB 4 PERFORMANCEDIAGNOSTIC TEST
2011 Dodge and Ram Journey R/T, AWD
Diagnostic Test
2011 Dodge and Ram Journey R/T, AWDSECTION Diagnostic Test
- TEST FOR INTERMITTENT CONDITION NOTE:
All FOBIKs used with this vehicle should be present during this test.
- With one of the owners good FOBIKs, turn the ignition on.
- With the scan tool, record and erase the DTCs.
- Operate the alleged inoperative FOBIK in all positions several times.
- With the scan tool, read the DTCs.
Does the scan tool display this DTC as active?
Yes
- Go To 2.
No
- The conditions that caused this code to set are not present at this time. The FOBIK may have already been re-syncronized by being in the vehicle while it was being driven. Inform the owner of the most probable cause for this code to set and therefore causing the FOBIK to be inoperative.
- Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.
- TEST DRIVE THE VEHICLE
- With the scan tool, erase the DTCs.
- Turn the ignition off.
- Put the inoperative FOBIK in the vehicle.
- With the good FOBIK, start and drive the vehicle above five miles per hour for one mile.
- Turn the ignition off.
- Operate the inoperative FOBIK in all positions several times.
- With the scan tool, read the DTCs.
Does the scan tool display this DTC as active?
Yes
- Replace the FOBIK and program using the scan tool.
- Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.
No
- Test complete.
- Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.