Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2011GRAND CARAVAN V6-3.6LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BODY AND FRAMESEAT TEMPERATURE CONTROL MODULESERVICE AND REPAIRHEATED SEAT MODULE - INSTALLATION
2011 Dodge and Ram Grand Caravan V6-3.6L
Heated Seat Module - Installation
2011 Dodge and Ram Grand Caravan V6-3.6LSECTION Heated Seat Module - Installation
INSTALLATION
CAUTION: Properly align the Heated Seat Module (HSM) retaining tab to the hole in the seat pan, prior to engagement. Failure to follow these instructions may result in damage to the plastic HSM housing and retaining tab.
1. Position the Heated Seat Module (HSM) (3) to the seat pan (1) and connect the wire harness connector (4).
2. Align the HSM retaining tab (2) to the hole in the seat pan and enage the retaining tab to the seat. Firmly apply even pressure to the HSM until the retaining tab is fully engaged.
3. Reconnect the negative battery cable.
4. Check for proper heated seat system operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.