Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2011GRAND CARAVAN V6-3.6LREPAIR AND DIAGNOSISLIGHTING AND HORNSHEADLAMPHEADLAMP ALIGNMENT CONTROL MODULESERVICE AND REPAIRHEADLAMP LEVELING MODULE - INSTALLATION
2011 Dodge and Ram Grand Caravan V6-3.6L
Headlamp Leveling Module - Installation
2011 Dodge and Ram Grand Caravan V6-3.6LSECTION Headlamp Leveling Module - Installation
INSTALLATION
1. Position the Automatic Headlamp Leveling Module (AHLM) (also known as the High Intensity Discharge Transducer/HIDT) (1) and mounting strap over the studs on the top of the left inner rear wheel housing (3) as a unit.
2. Install and tighten the two nuts (2) that secure the mounting strap of the AHLM to the two studs on the top of the left inner rear wheel housing. Tighten the nuts to 11 Nm (8 ft. lbs.).
3. Reconnect the body wire harness connector to the connector receptacle of the AHLM.
4. Reinstall the trim onto the left quarter inner panel. Quarter Trim Panel - Installation.
5. Reconnect the battery negative cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.