Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2011CHALLENGER SRT-8 V8-6.4LREPAIR AND DIAGNOSISBODY AND FRAMEMIRRORSSERVICE AND REPAIROUTSIDE REARVIEW MIRROR - REMOVAL
2011 Dodge and Ram Challenger SRT-8 V8-6.4L
Outside Rearview Mirror - Removal
2011 Dodge and Ram Challenger SRT-8 V8-6.4LSECTION Outside Rearview Mirror - Removal
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the door trim panel. Front Door Trim Panel - Removal.
3. Remove the water shield.
4. Disconnect the door wire harness connector from the mirror electrical connector.
5. Remove the three nuts that secure the outside rearview mirror to the front door.
6. Remove the outside rearview mirror from the front door.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.