Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2010JOURNEY AWD V6-3.5LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINTRANSFER CASECONTROL MODULESERVICE AND REPAIRFINAL DRIVE CONTROL MODULE - REMOVAL
2010 Dodge and Ram Journey AWD V6-3.5L
Final Drive Control Module - Removal
2010 Dodge and Ram Journey AWD V6-3.5LSECTION Final Drive Control Module - Removal
REMOVAL
1. Remove the left front trim panel.
2. Remove the electrical connector.
3. Remove the mounting nuts.
4. Remove the ECC module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.