Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2009DURANGO 4WD V8-5.7L HYBRIDREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINTRANSFER CASERELAYS AND MODULES - TRANSFER CASECONTROL MODULEDESCRIPTION AND OPERATIONFINAL DRIVE CONTROL MODULE - DESCRIPTION
2009 Dodge and Ram Durango 4WD V8-5.7L Hybrid
Final Drive Control Module - Description
2009 Dodge and Ram Durango 4WD V8-5.7L HybridSECTION Final Drive Control Module - Description
DESCRIPTION
FDCM (Final Drive Control Module) is an electronic module that controls the shifting of the AWD new "Active on Demand" MP3010 single speed transfer case. This plastic cased module is packaged in the (Pedal Assembly) MAG bracket for the HB/HG HEV vehicle. Communication is via the CAN serial bus.
The FDCM is installed inside the passenger compartment behind the driver side knee bolster.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.