Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2009DURANGO 4WD V8-5.7L HYBRIDREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL LEVEL SENSORSERVICE AND REPAIRFUEL PUMP MODULE - REMOVAL
2009 Dodge and Ram Durango 4WD V8-5.7L Hybrid
Fuel Pump Module - Removal
2009 Dodge and Ram Durango 4WD V8-5.7L HybridSECTION Fuel Pump Module - Removal
REMOVAL
WARNING: The fuel system is under a constant pressure, even with the engine off. Before servicing the fuel pump module, the fuel system pressure must be released.
1. Perform the fuel system pressure release procedure Service and Repair
2. Disconnect and isolate the negative battery cable.
3. Drain and remove the fuel tank Fuel Tank - Removal
4. Note the rotational position of the module before attempting removal. An indexing arrow is located on top of the module for this purpose.
5. Position the lock ring remover/installer 9340 (3) into the notches on the outside edge of the lock ring (5).
6. Install a 1/2 inch drive breaker bar (1) into the lock ring remover/installer 9340 (3).
7. Rotate the breaker bar counterclockwise to remove the lock ring.
8. Remove the lock ring. The module will spring up slightly when the lock ring is removed.
9. Remove the module from the fuel tank. Be careful not to bend the float arm during removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.