Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSDODGE AND RAM2009DURANGO 4WD V8-5.7L HYBRIDREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINETESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESENGINE DIAGNOSIS - INTRODUCTION
2009 Dodge and Ram Durango 4WD V8-5.7L Hybrid
Engine Diagnosis - Introduction
2009 Dodge and Ram Durango 4WD V8-5.7L HybridSECTION Engine Diagnosis - Introduction
INTRODUCTION
Engine diagnosis is helpful in determining the causes of malfunctions not detected and remedied by routine maintenance.
These malfunctions may be classified as either performance (e.g., engine idles rough and stalls) or mechanical (e.g., a strange noise).
Component Tests and General Diagnostics for possible causes and corrections of malfunctions.
Additional tests and diagnostic procedures may be necessary for specific engine malfunctions that can not be isolated with the Service Diagnosis charts. Information concerning additional tests and diagnosis is provided within the following diagnosis:
- Cylinder Compression Pressure Test Cylinder Compression Pressure Test.
- Cylinder Combustion Pressure Leakage Test Cylinder Combustion Pressure Leakage Test.
- Engine Cylinder Head Gasket Failure Diagnosis Testing and Inspection.
- Intake Manifold Leakage Diagnosis Testing and Inspection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.