Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2009AVENGER V6-2.7L FLEX FUELREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL LEVEL SENSORSERVICE AND REPAIRREMOVALFLEX FUEL LEVEL SENSOR
2009 Dodge and Ram Avenger V6-2.7L Flex Fuel
Flex Fuel Level Sensor
2009 Dodge and Ram Avenger V6-2.7L Flex FuelSECTION Flex Fuel Level Sensor
FLEX FUEL LEVEL SENSOR
1. Remove fuel pump module, Fuel Tank - Installation.
NOTE: Mark the position of the fuel level sensor on the fuel pump module housing prior to removing. The correct position of the wires are critical to proper operation of the fuel level sensor. Mark the position of the wire prior to removing.
2. Use a terminal removal tool and remove negative electrical wire (3) from fuel level sensor.
3. Remove positive electrical wire (4) from fuel level sensor.
4. Remove fuel level sensor retaining tabs (1) from fuel pump module housing (2).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.