Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2009AVENGER V6-2.7L FLEX FUELREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL LEVEL SENSORSERVICE AND REPAIRFUEL PUMP MODULE - INSTALLATION
2009 Dodge and Ram Avenger V6-2.7L Flex Fuel
Fuel Pump Module - Installation
2009 Dodge and Ram Avenger V6-2.7L Flex FuelSECTION Fuel Pump Module - Installation
INSTALLATION
1. Wipe seal area of tank clean and install a new O-ring seal to fuel tank.
2. Connect fuel line between fuel pump module (1) and fuel level unit (2), if equipped with AWD.
3. Install fuel pump module to fuel tank.
4. Position fuel pump module into fuel tank, line up module with mark made during removal procedure. Install fuel pump module lock using SAE Fuel Pump Lock Ring Wrench 9340. Tighten until the lockring and fuel pump module is fully seated.
5. Connect fuel line (3) to fuel pump module (1).
6. Connect the electrical connector (2).
7. Connect the battery cable.
8. Fill fuel tank. Use the scan tool to pressurize the fuel system. Check for leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.