Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2006STRATUS SXT, 2.4 XREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSPOWER WINDOWSWINDOW DROP RELAYREMOVAL
2006 Dodge and Ram Stratus SXT, 2.4 X
Window Drop Relay: Removal
2006 Dodge and Ram Stratus SXT, 2.4 XSECTION Removal
- Disconnect and isolate the battery negative cable.
- Remove door trim panel.
- Peel back the waterdam to expose the window drop relay.
- Disconnect the wire harness connector.
- Remove the window drop relay from the door panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.