Parking Lamp: Service and Repair

2006 Dodge and Ram Magnum V6-2.7L VIN TSECTION Service and Repair
FRONT PARK/TURN SIGNAL LAMP

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. From atop the headlamp unit, reach behind and just below the upper radiator crossmember and twist the park/turn signal lamp socket out.
3. Remove the lamp from the socket.

INSTALLATION




1. Install lamp into socket.
2. Install lamp socket (1) into the headlamp unit. Twist socket clockwise.
3. Connect the battery negative cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.