Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2006MAGNUM V6-2.7L VIN TREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONB CODE CHARTSB2219BODY CONTROL SYSTEM
2006 Dodge and Ram Magnum V6-2.7L VIN T
Body Control System
2006 Dodge and Ram Magnum V6-2.7L VIN TSECTION Body Control System
B2218,B2219 - DOOR MODULE INTERNAL
WHEN MONITORED
Ignition on.
SET CONDITION
This code is set immediately if the Driver/Passenger Door Module internal self test fails.
POSSIBLE CAUSES
- Driver/passenger door module
Diagnostic Test
1. VERIFY THAT DTC B2218, B2219-DOOR MODULE INTERNAL IS ACTIVE
With the scan tool, record and erase DTC's.
Cycle the ignition switch off then back on.
With the scan tool, read DTC's.
Q: Does the DTC B2218 or B2219 - DOOR MODULE INTERNAL reset?
YES: Replace the appropriate Door Module.
Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
NO: The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
WHEN MONITORED
Ignition on.
SET CONDITION
This code is set immediately if the Driver/Passenger Door Module internal self test fails.
POSSIBLE CAUSES
- Driver/passenger door module
Diagnostic Test
1. VERIFY THAT DTC B2218, B2219-DOOR MODULE INTERNAL IS ACTIVE
With the scan tool, record and erase DTC's.
Cycle the ignition switch off then back on.
With the scan tool, read DTC's.
Q: Does the DTC B2218 or B2219 - DOOR MODULE INTERNAL reset?
YES: Replace the appropriate Door Module.
Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
NO: The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.