SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2006MAGNUM SE, 42RLEREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSCONNECTOR END VIEWSCONNECTOR PIN-OUTSFRONT CONTROL IPM MODULE CONNECTOR END VIEW
2006 Dodge and Ram Magnum SE, 42RLE

Front Control Ipm Module Connector End View

2006 Dodge and Ram Magnum SE, 42RLESECTION Front Control Ipm Module Connector End View
MODULE-FRONT CONTROL IPM - BLACK 49 WAY

GCLX680254Courtesy of DAIMLERCHRYSLER CORP.
CAV CIRCUIT FUNCTION
1 - -
2 A906 FUSED B(+)
3 A902 FUSED B(+)
4 A901 FUSED B(+)
5 A903 FUSED B(+)
6 - -
7 L1 BACKUP LAMP FEED
8 - -
9 - -
10 W24 (HID LAMPS) HEADLAMP WASHER RELAY CONTROL
11 W20 (LX49) REAR WASHER PUMP MOTOR CONTROL
12 W10 FRONT WASHER PUMP MOTOR CONTROL
13 F902 IGNITION UNLOCK-RUN-START
14 K361 (DIESEL) PTC NO. 2 RELAY CONTROL
15 X13 FUSED B(+) (I.O.D.)
16 K360 (DIESEL) PTC NO. 1 RELAY CONTROL
17 F202 FUSED IGNITION SWITCH OUTPUT (RUN-START)
18 Z901 GROUND
19 - -
20 - -
21 L239 (EXPORT) REAR FOG LAMP RELAY CONTROL
22 F923 RUN RELAY CONTROL
23 - -
24 - -
25 Z901 GROUND
26 L139 FRONT FOG LAMP RELAY CONTROL
27 W5 WIPER ON/OFF RELAY CONTROL
28 W12 (LX49) REAR WIPER RELAY CONTROL
29 W2 WIPER HIGH/LOW RELAY CONTROL
30 K542 ASD RELAY OUTPUT
31 W7 FRONT WIPER PARK SWITCH SENSE
32 - -
33 Z901 GROUND
34 L62 RIGHT REAR TURN SIGNAL CONTROL
35 C918 A/C PRESSURE SENSOR GROUND
36 - -
37 - -
38 P307 ACCESSORY DELAY RELAY CONTROL
39 N201 RADIATOR FAN CONTROL RELAY CONTROL
40 - -
41 Z901 GROUND
42 - -
43 L63 LEFT REAR TURN SIGNAL CONTROL
44 - -
45 N112 RADIATOR FAN HIGH RELAY CONTROL
46 P201 (EXCEPT MEMORY) ADJUSTABLE PEDALS RELAY CONTROL
47 X4 HORN RELAY CONTROL
48 L177 PARK LAMP RELAY CONTROL
49 K175 (AWD/SRT8/DIESEL) RADIATOR FAN RELAY COIL SIGNAL
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.