Wipers/Washers DTCS

2006 Dodge and Ram Magnum SE, 42RLESECTION Wipers/Washers DTCS
WIPERS/WASHERS DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description
B2211 RAIN SENSOR MODULE INITIALIZATION PERFORMANCE
B2304 WIPER PARK SWITCH INPUT CIRCUIT LOW
B2305 WIPER PARK SWITCH INPUT CIRCUIT HIGH
B2313 WIPER ON/OFF CONTROL CIRCUIT LOW
B2314 WIPER ON/OFF CONTROL CIRCUIT HIGH
B2315 WIPER ON/OFF CONTROL CIRCUIT OPEN
B2317 WIPER HI/LOW CONTROL CIRCUIT LOW
B2318 WIPER HI/LOW CONTROL CIRCUIT HIGH
B2319 WIPER HI/LOW CONTROL CIRCUIT OPEN
B2320 FRONT/REAR WASHER MOTOR CONTROL CIRCUIT HIGH
B2321 FRONT/REAR WASHER MOTOR CONTROL CIRCUIT OPEN
B2323 HEADLAMP WASHER MOTOR CONTROL CIRCUIT LOW
B2324 HEADLAMP WASHER MOTOR CONTROL CIRCUIT HIGH
B2325 HEADLAMP WASHER MOTOR CONTROL CIRCUIT OPEN
B2328 WASHER FLUID LEVEL SENSOR INPUT CIRCUIT HIGH
B2329 RAIN SENSOR OPTICAL PATH 1 PERFORMANCE
B2340 FRONT/REAR WASHER MOTOR CONTROL CIRCUIT OPEN
B2343 FRONT/REAR WASHER MOTOR CONTROL CIRCUIT HIGH
B210D BATTERY VOLTAGE LOW (RSM)
B210E BATTERY VOLTAGE HIGH (RSM)
B221D (RSM) RAIN SENSOR MODULE INTERNAL
B230D REAR WIPER PARK SWITCH INPUT CIRCUIT LOW
B230E REAR WIPER PARK SWITCH INPUT CIRCUIT OPEN
B231B REAR WIPER MOTOR CONTROL CIRCUIT LOW
B231C REAR WIPER MOTOR CONTROL CIRCUIT HIGH
B231D REAR WIPER MOTOR CONTROL CIRCUIT OPEN
B231F FRONT/REAR WASHER MOTOR CONTROL CIRCUIT LOW
B232A RAIN SENSOR OPTICAL PATH 2 PERFORMANCE
B232B RAIN SENSOR OPTICAL PATH 3 PERFORMANCE
B232C RAIN SENSOR OPTICAL PATH 4 PERFORMANCE
U0019 CAN B BUS (RSM)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.