Power Top & Sunroof (Service Information): Motor/Module-Sunroof: Removal

2006 Dodge and Ram Magnum SE, 42RLESECTION Removal
WARNING: The Excessive Force Limitation (EFL) feature must be calibrated any time a sunroof motor/module is replaced with a new component. Failure to perform this procedure could result in vehicle damage and/or personal injury. Refer to EXCESSIVE FORCE LIMITATION (EFL) CALIBRATIONΒ  for the appropriate procedure.
  1. Disconnect the battery negative cable.
  2. Remove the vehicle headliner, (Refer to BODY/INTERIOR/HEADLINER - REMOVAL) .
    Fig 1: Locating Sunroof Motor/Module
    GC0016421Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove the power sunroof motor/module electrical connector (2).
  4. Remove the retaining screws (3) and remove the motor/module (1) from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.