SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2006GRAND CARAVAN BASE, 3.3 EREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTMIRRORSPOWER MIRRORSREMOTE SWITCHDIAGNOSIS AND TESTINGREMOTE SWITCH
2006 Dodge and Ram Grand Caravan Base, 3.3 E

Remote Switch

2006 Dodge and Ram Grand Caravan Base, 3.3 ESECTION Remote Switch
  1. Remove power mirror switch. (Refer to ELECTRICAL/POWER MIRRORS/POWER MIRROR SWITCH - REMOVAL) .
  2. Disconnect wiring harness at switch connector.
  3. Using a ohmmeter, test for continuity between the terminals of the switch. See Fig 1.
    Fig 1: Identifying Mirror Switch Terminals
    GC0024795Courtesy of DAIMLERCHRYSLER CORP.
    MIRROR SWITCH TEST

    - MIRROR SELECT SWITCH IN "LEFT" POSITION 
    Move Button  Continuity Between 
    UP PIN 9 - PIN 12,
    PIN 6 - PIN 11,
    PIN 9 - PIN 13
    LEFT PIN 9 - PIN 7,
    PIN 6 - PIN 11,
    PIN 9 - PIN 8
    DOWN PIN 9 - PIN 6,
    PIN 12 - PIN 11,
    PIN 13 - PIN 11
    RIGHT PIN 9 - PIN 6,
    PIN 7 - PIN 11,
    PIN 8 - PIN 11
    - MIRROR SELECT SWITCH IN "RIGHT" POSITION 
    Move Button  Continuity Between 
    UP PIN 9 - PIN 13,
    PIN 1 - PIN 11,
    PIN 9 - PIN 12
    LEFT PIN 9 - PIN 8,
    PIN 1 - PIN 11,
    PIN 9 - PIN 7
    DOWN PIN 9 - PIN 1,
    PIN 13 - PIN 11,
    PIN 12 - PIN 11
    RIGHT PIN 9 - PIN 1,
    PIN 8 - PIN 11,
    PIN 7 - PIN 11
  4. If results shown in the table are not obtained, replace the switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.