Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSDODGE AND RAM2006CARAVAN SE, 3.3 EREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMPOWERTRAIN DIAGNOSTIC PROCEDURESSYSTEM DESCRIPTION AND FUNCTIONAL OPERATIONFUNCTIONAL OPERATIONPROGRAMMING THE SKREEM

2006 Dodge and Ram Caravan SE, 3.3 E

Programming The SKREEM

2006 Dodge and Ram Caravan SE, 3.3 ESECTION Programming The SKREEM

NOTE: If the PCM and the SKREEM are replaced at the same time, program the VIN into the PCM first. All vehicle keys will then need to be replaced and programmed to the new SKREEM.

Turn the ignition on (transmission in park/neutral).
Use the DRBIII® and select THEFT ALARM, SKREEM then MISCELLANEOUS.
Select SKREEM MODULE REPLACEMENT (GASOLINE).
Program the vehicle four-digit PIN into the SKREEM.
Select COUNTRY CODE and enter the correct country.
NOTE: Be sure to enter the correct country code. If the incorrect country code is programmed into SKREEM, the SKREEM must be replaced.
Select UPDATE VIN (the SKREEM will learn the VIN from the PCM).
Press ENTER to transfer the VIN (the PCM will send the VIN to the SKREEM).
The DRBIII® will ask if you want to transfer the secret key. Select ENTER to transfer secret key from the PCM. This will ensure the current vehicle ignition keys will still operate the SKREES system.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.