Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2005NEON SE, STANDARDREPAIR AND DIAGNOSISELECTRICALCHARGING SYSTEMSCHARGINGBATTERY TEMPERATURE SENSORINSTALLATION
2005 Dodge and Ram Neon SE, Standard
Battery Temperature Sensor: Installation
2005 Dodge and Ram Neon SE, StandardSECTION Installation
- Install the Battery Temperature Sensor to the thermal guard. See Figure.
- Carefully install the thermal guard over the battery.
- Connect the Battery Temperature Sensor electrical connector.
- Connect the battery positive cable then the negative cable.
- Close hood.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.