SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2005NEON SE, STANDARDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULESPOWERTRAIN CONTROL MODULESTANDARD PROCEDURESTANDARD PROCEDURE - QUICK LEARN PROCEDURE
2005 Dodge and Ram Neon SE, Standard

Standard Procedure - Quick Learn Procedure

2005 Dodge and Ram Neon SE, StandardSECTION Standard Procedure - Quick Learn Procedure

The quick learn procedure requires the use of the DRBIII® scan tool. This program allows the PCM to recalibrate itself. This will provide the best possible transaxle operation.

NOTE: The quick learn procedure should be performed if any of the following procedures are performed:
  1. Transaxle Assembly Replacement
  2. Powertrain Control Module Replacement
  3. Solenoid/Pressure Switch Assembly Replacement
  4. Clutch Plate and/or Seal Replacement
  5. Valve Body Replacement or Recondition

To perform the Quick Learn Procedure, the following conditions must be met:

  1. The brakes must be applied
  2. The engine speed must be above 500 rpm
  3. The throttle angle (TPS) must be less than 3 degrees
  4. The shift lever position must stay until prompted to shift to overdrive
  5. The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the DRBIII® indicates the procedure is complete
  6. The calculated oil temperature must be above 60° and below 200°
  1. Plug the DRBIII® scan tool into the diagnostic connector. The connector is located under the instrument panel.
  2. Go to the Transmission screen.
  3. Go to the Miscellaneous screen.
  4. Select Quick Learn Procedure. Follow the instructions of the DRBIII® to perform the Quick Learn Procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.