Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2005MAGNUM R/T, AWDREPAIR AND DIAGNOSISRESTRAINTSSEAT BELTSRESTRAINTS SYSTEM (SERVICE INFORMATION)SEAT TRACK POSITION SENSORINSTALLATION
2005 Dodge and Ram Magnum R/T, AWD
Seat Track Position Sensor: Installation
2005 Dodge and Ram Magnum R/T, AWDSECTION Installation
- Position the seat track position sensor (3) on the end of the bracket (1) located on the lower outboard seat track (5).
- Push the sensor firmly into the bracket until the snap feature (2) locks into place.
- Connect the electrical connector (4) to the sensor.
WARNING:
Do not connect the battery negative cable (Refer to AIRBAG SYSTEM ).
. Personal injury or death may result if the system test is not performed first.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.