Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSDODGE AND RAM2005MAGNUM R/T, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSCONNECTOR END VIEWSCONNECTOR PIN-OUTSINTEGRATED POWER MODULE CONNECTOR END VIEW (C5)
2005 Dodge and Ram Magnum R/T, AWD
Integrated Power Module Connector End View (C5)
2005 Dodge and Ram Magnum R/T, AWDSECTION Integrated Power Module Connector End View (C5)
MODULE-INTEGRATED POWER C5 - BLUE 26 WAY
| CAV | CIRCUIT | FUNCTION |
| 1 | - | - |
| 2 | - | - |
| 3 | T751 20YL | FUSED IGNITION SWITCH OUTPUT (START) |
| 4 | T752 20DG/OR | STARTER RELAY CONTROL |
| 5 | T750 16YL/GY | STARTER RELAY OUTPUT |
| 6 | A209 18RD | FUSED B(+) |
| 7 | - | - |
| 8 | - | - |
| 9 | - | - |
| 10 | - | - |
| 11 | X13 16DG/GY | FUSED B(+) (I.O.D.) |
| 12 | W7 20BR/GY | FRONT WIPER PARK SWITCH SENSE |
| 13 | - | - |
| 14 | - | - |
| 15 | K51 20BR/WT | AUTO SHUT DOWN RELAY CONTROL |
| 16 | - | - |
| 17 | K342 18BR/WT | FUSED AUTO SHUT DOWN RELAY OUTPUT 1 |
| 18 | - | - |
| 19 | - | - |
| 20 | L777 20WT/VT | PARK LAMP RELAY OUTPUT |
| 21 | - | - |
| 22 | Z901 16BK/DG | GROUND |
| 23 | W20 20BR/YL | REAR WASHER PUMP MOTOR CONTROL |
| 24 | - | - |
| 25 | K344 18BR/GY | FUSED AUTO SHUT DOWN RELAY OUTPUT 3 |
| 26 | K343 16BR/YL | FUSED AUTO SHUT DOWN RELAY OUTPUT 2 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.