Antenna Cable: Installation

2005 Dodge and Ram Magnum R/T, AWDSECTION Installation
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE) .
  1. Position antenna cable and secure to wire harness.
  2. Connect antenna cable to antenna module.
  3. Connect antenna cable to instrument panel antenna cable.
  4. Install right side C-pillar trim panel (Refer to BODY/INTERIOR/C-PILLAR TRIM - INSTALLATION) .
  5. Install right side front and rear door scuff plates (Refer to BODY/INTERIOR/DOOR SILL SCUFF PLATE - INSTALLATION) .
  6. Install right side cowl trim panel. (Refer to INTERIOR/EXTERIOR ).
  7. Connect battery negative cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.