Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2000RAM 2500 VAN V8-5.2L CNG VIN TREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRWHEEL ALIGNMENTWHEEL ALIGNMENT SETUP
2000 Dodge and Ram RAM 2500 Van V8-5.2L CNG VIN T
Wheel Alignment Setup
2000 Dodge and Ram RAM 2500 Van V8-5.2L CNG VIN TSECTION Wheel Alignment Setup
The front wheel alignment angles should be set to preferred specifications. This will prevent abnormal tire tread wear.
Before each alignment reading the vehicle should be jounced (rear first, then front). Grasp each bumper at the center and jounce the vehicle up and down several times. Always release the bumper in the down position.
Before each alignment reading the vehicle should be jounced (rear first, then front). Grasp each bumper at the center and jounce the vehicle up and down several times. Always release the bumper in the down position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.