Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2000RAM 2500 VAN V8-5.2L CNG VIN TREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERTESTING AND INSPECTIONPROGRAMMING AND RELEARNING
2000 Dodge and Ram RAM 2500 Van V8-5.2L CNG VIN T
Programming and Relearning
2000 Dodge and Ram RAM 2500 Van V8-5.2L CNG VIN TSECTION Programming and Relearning
WITHOUT VEHICLE THEFT SECURITY SYSTEM
1. Locate the dark green program enable wire connected to the terminal in cavity 1 of the 16-way data link connector under the left side of the instrument panel.
2. Connect the program enable wire terminal to a good ground.
3. Insert the key into the ignition lock cylinder and turn the ignition switch to the ON position. The power locks will cycle (Lock, then Unlock) as feedback.
4. Depress either button on one Remote Keyless Entry (RKE) transmitter. The power locks will cycle as feedback.
5. Depress either button on the second transmitter, if used. The power locks will cycle as feedback.
6. Disconnect the program enable wire terminal from ground.
7. Turn the ignition switch to the OFF position and remove the key.
8. Test the operation of the RKE transmitter(s).
WITH VEHICLE THEFT SECURITY SYSTEM
To program the Remote Keyless Entry (RKE) transmitter access codes into the RKE receiver in the Central Timer Module (CTM) requires the use of a DRB scan tool. Refer to the proper Diagnostic Procedures for more information.
16-Way Data Link Connector - Typical:
1. Locate the dark green program enable wire connected to the terminal in cavity 1 of the 16-way data link connector under the left side of the instrument panel.
2. Connect the program enable wire terminal to a good ground.
3. Insert the key into the ignition lock cylinder and turn the ignition switch to the ON position. The power locks will cycle (Lock, then Unlock) as feedback.
4. Depress either button on one Remote Keyless Entry (RKE) transmitter. The power locks will cycle as feedback.
5. Depress either button on the second transmitter, if used. The power locks will cycle as feedback.
6. Disconnect the program enable wire terminal from ground.
7. Turn the ignition switch to the OFF position and remove the key.
8. Test the operation of the RKE transmitter(s).
WITH VEHICLE THEFT SECURITY SYSTEM
To program the Remote Keyless Entry (RKE) transmitter access codes into the RKE receiver in the Central Timer Module (CTM) requires the use of a DRB scan tool. Refer to the proper Diagnostic Procedures for more information.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.