Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2000PICKUP R1500, 4D PICKUP EXTRA CAB, 5.2 Y, RWD, AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEBODY, CAB CONTROL SYSTEMSBODY CONTROL MODULESSYSTEM TESTSWINDSHIELD WIPER SYSTEMWIPER SPEED SENSITIVE FEATURE INOPERATIVE
2000 Dodge and Ram Pickup R1500, 4D Pickup Extra Cab, 5.2 Y, RWD, Automatic
Wiper Speed Sensitive Feature Inoperative
2000 Dodge and Ram Pickup R1500, 4D Pickup Extra Cab, 5.2 Y, RWD, AutomaticSECTION Wiper Speed Sensitive Feature Inoperative
- Turn ignition on. Using scan tool, select CENTRAL TIMER MODULE. If scan tool displays NO RESPONSE, go to NO RESPONSE CENTRAL TIMER MODULE under COMMUNICATIONS. If scan tool displays any CCD bus failure message, go to appropriate test under COMMUNICATIONS . If scan tool does not display NO RESPONSE or any CCD bus failure message, go to next step.
- Raise and support vehicle. Turn wipers on to longest interval intermittent position. Time interval between wipes. Spin rear wheels to more than 15 MPH. If interval between wipes increased to approximately 18 seconds, system is currently functioning properly. If interval between wipes did not increase to approximately 18 seconds, replace CTM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.