Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Controls - Self Diagnostics: Introduction
Perform all steps in appropriate BASIC DIAGNOSTICS PROCEDURES article. If no fault is found while performing basic diagnostic procedures, proceed with self-diagnostics. If no Diagnostic Trouble Codes (DTCs) are present after entering self-diagnostics, perform TEST NTC-1: NO TROUBLE CODE TEST MENU located after DTC tests under DIAGNOSTIC TESTS for engine diagnosis. If after performing TEST NTC-1, problem is not identified and repaired, proceed to appropriate TROUBLE SHOOTING - NO CODES - EXCEPT DIESEL article for diagnosis by symptom.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.