Headlights Fail To Flash During Alarm

2000 Dodge and Ram Neon ES, AutomaticSECTION Headlights Fail To Flash During Alarm
NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS. Unless instructed otherwise in test step, reconnect any disconnected connectors.
  1. Ensure low beam headlights are operating properly. Repair low beam headlights as necessary. If low beam headlights are operating properly, go to next step.
  2. Turn ignition off. Disconnect Remote Keyless Entry (RKE) module connector. Connect a 12-volt test light between ground and RKE module connector terminal No. 1, dimmer switch low beam output circuit (Violet/White wire). See Figure. Turn low beam headlights on. If test light illuminates, replace RKE module. See REMOTE KEYLESS ENTRY (RKE) MODULE  under REMOVAL & INSTALLATION. If test light does not illuminate, repair open Violet/White wire.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.