Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2000NEON ES, AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEBODY, CAB CONTROL SYSTEMSBODY CONTROL MODULESSYSTEM TESTSINSTRUMENT CLUSTERACM MESSAGES NOT RECEIVED BY MIC
2000 Dodge and Ram Neon ES, Automatic
ACM Messages Not Received By MIC
2000 Dodge and Ram Neon ES, AutomaticSECTION ACM Messages Not Received By MIC
- Turn ignition off. Connect scan tool to Data Link Connector (DLC). DLC is located on bottom of instrument panel, to left of brake pedal. See Figure. Go to next step.
- Turn ignition on. Using scan tool, select PASSIVE RESTRAINTS, then AIRBAG. If Air Bag Control Module (ACM) responds, no problem is found at this time. Test is complete. If ACM does not respond, perform NO RESPONSE FROM ACM test under COMMUNICATIONS.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.