Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Overdrive Clutch Reassembly
2000 Dodge and Ram Intrepid R/TSECTION Overdrive Clutch Reassembly
- Install overdrive clutch plates and overdrive clutch discs. See Figure . Install waved snap ring. Install reverse-overdrive clutch pressure plate with stepped side downward. See Figure .
- Using press and spring compressor, press reverse-overdrive clutch pressure plate downward to compress overdrive clutch assembly until flat snap ring can be installed. Install flat snap ring. Release press. Remove spring compressor. Check overdrive clutch clearance.
CAUTION:
When compressing overdrive clutch assembly, compress assembly just enough to install flat snap ring.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.