Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
MULTIFUNCTION Switch
Disconnect negative battery cable. Disconnect multifunction switch connector. Check continuity between appropriate switch terminals with switch in specified position. See MULTIFUNCTION SWITCH TESTING and WIPER/WASHER SWITCH CONTINUITY tables. See Fig 1 and Fig 2 . If continuity is not as specified, replace switch.
| Switch Position | Continuity Between Terminals No. | |||
|---|---|---|---|---|
| Turn Signals | ||||
| Neutral | (1) | |||
| Left | 6 & 7 | |||
| Right | 7 & 8 | |||
| Hazards On | 4 & 5; 6 & 7; 7 & 8 | |||
| Head Lights | ||||
| Low Beam | (1) | |||
| High Beam | 4 & 7 | |||
| Flash-To-Pass | 5 & 7 | |||
|
||||
| Switch Position | Between Terminals No. | K/Ohms | |||
|---|---|---|---|---|---|
| Off | 1 & 3 | 300 Or More | |||
| Delay Level | |||||
| 1 | 1 & 3 | 9.72 | |||
| 2 | 1 & 3 | 8.22 | |||
| 3 | 1 & 3 | 6.61 | |||
| 4 | 1 & 3 | 5.12 | |||
| 5 | 1 & 3 | 3.67 | |||
| 6 | 1 & 3 | 2.22 | |||
| Low | 1 & 3 | 1.02 | |||
| High | 1 & 3 | 0.51 | |||
| Wash | 1 & 2 | (1) | |||
|
|||||
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.