Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2000INTREPID ES, 2.7 ULABOR TIMESOTHER VARIANTENGINE MECHANICALMECHANICALVALVEGRIND COMPLETE
2000 Dodge and Ram Intrepid ES, 2.7 U
Grind Complete
2000 Dodge and Ram Intrepid ES, 2.7 USECTION Grind Complete
WARNING: This page is about the Intrepid Base, which is a different variant/trim than selected.
Includes: Remove carbon, check surfaces for warpage, reface or replace Valves, resurface Valve Seats and clean Valve Guides. Adjust Valves (where applicable).| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 2.7L Eng, Both Heads | 14.7 | A | ||
| Combination Procedure: VALVE SPRING ASSEMBLED HEIGHT: Correct: | ||||
| Per 3 Springs | 0.2 | A | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.