Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1999DAKOTA SLT, 2D PICKUP, 3.9 X, 4WD, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEBODY, CAB CONTROL SYSTEMSBODY CONTROL COMPUTERPOWER DOOR LOCK SYSTEMAUTOMATIC (ROLLING) DOOR LOCKS INOPERATIVE
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, Standard
Automatic (Rolling) Door Locks Inoperative
1999 Dodge and Ram Dakota SLT, 2D Pickup, 3.9 X, 4WD, StandardSECTION Automatic (Rolling) Door Locks Inoperative
NOTE:
For connector terminal identification and wiring diagrams, see
BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST VER-1A
after each repair.
- Using scan tool select SYSTEM MONITORS, then CCD BUS TEST. If scan tool displays BUS OPERATIONAL, go to next step. If scan tool does not display BUS OPERATIONAL, go to appropriate VEHICLE COMMUNICATIONS article.
- Using scan tool select BODY COMPUTER. If scan tool displays NO RESPONSE, go to appropriate VEHICLE COMMUNICATIONS article. If scan tool displays NO RESPONSE, go to next step.
- This test is only for vehicles equipped with speed sensitive door locks. With doors closed and unlocked drive vehicle faster than 15 MPH. If doors lock, system is currently functioning properly. If doors do not lock, using scan tool select ROLLING LOCKS. Retest system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.