Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1999CARAVAN BASE, 2.4 BREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSOVERHAUL - 31THTORQUE SPECIFICATIONS
1999 Dodge and Ram Caravan Base, 2.4 B
Torque Specifications
1999 Dodge and Ram Caravan Base, 2.4 BSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Differential Bearing Retainer Bolt | 21 (29) | ||
| Differential Cover Bolt | 14 (19) | ||
| End Cover Bolt | 14 (19) | ||
| Extension Housing Bolt | 21 (29) | ||
| Governor Counterweight Bolt | 21 (29) | ||
| Kickdown Band Adjusting Screw Lock Nut | 35 (47) | ||
| Neutral Start/Back-Up Light Switch | 25 (34) | ||
| Oil Pan Bolt | 14 (19) | ||
| Oil Pump-To-Transaxle Case Bolt | 23 (31) | ||
| Parking Rod Support Bolt | 21 (29) | ||
| Reaction Shaft Support Bolt | 21 (29) | ||
| Ring Gear Bolt (1) | 70 (95) | ||
| Transfer/Output Gear Bolt/Nut | 200 (271) | ||
| INCH Lbs. (N.m) | |||
| Governor Assembly-To-Governor Support Bolt | 60 (6.8) | ||
| Low-Reverse Band Adjusting Screw Lock Nut | 120 (13.6) | ||
| Oil Filter Assembly Screw | 45 (5.1) | ||
| Pressure Tap Plug | 45 (5.1) | ||
| Transfer Plate/Valve Body-To-Transaxle Case Bolt | 105 (12) | ||
| Valve Body Screw | 45 (5.1) | ||
| Vehicle Speed Sensor Bolt | 60 (6.8) | ||
|
|||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.