Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1999CARAVAN BASE, 2.4 BREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - TESTS W/CODESPOWERTRAIN CONTROL MODULEPOWERTRAIN CONTROL MODULE PROGRAMMINGPROGRAMMING PCM & CLEARING DTCS FROM ABS & SRS MODULES
1999 Dodge and Ram Caravan Base, 2.4 B
Programming PCM & Clearing DTCs From ABS & SRS Modules
1999 Dodge and Ram Caravan Base, 2.4 BSECTION Programming PCM & Clearing DTCs From ABS & SRS Modules
- Connect scan tool to Data Link Connector (DLC). The DLC is located below driver's side of instrument panel. See Figure.
- Using scan tool, enter correct VIN and mileage into PCM . Using scan tool manufacturer's instructions, clear DTCs from ABS and SRS modules.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.