Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1999CARAVAN BASE, 2.4 BREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEREMOVE, OVERHAUL & INSTALLENGINE CONTROLS - REMOVAL, OVERHAUL & INSTALLATIONCOMPUTERIZED ENGINE CONTROLSTRANSMISSION CONTROL MODULE (TCM)REMOVAL & INSTALLATION
1999 Dodge and Ram Caravan Base, 2.4 B
Removal & Installation
1999 Dodge and Ram Caravan Base, 2.4 BSECTION Removal & Installation
- The TCM is located on passenger's side front corner of engine compartment, on inner fender, near windshield washer reservoir. See Fig 1.
- Disconnect negative battery cable. Loosen retaining bolt at center of 60-pin electrical connector on TCM. Disconnect electrical connector from TCM. Remove screws and TCM. To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.