Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1996NEON L4-2.0L SOHCREPAIR AND DIAGNOSISMAINTENANCESERVICE INTERVALSNORMAL SERVICE75000 MI OR 120000 KM
1996 Dodge and Ram Neon L4-2.0L SOHC
75000 MI or 120000 KM
1996 Dodge and Ram Neon L4-2.0L SOHCSECTION 75000 MI or 120000 KM
Adjust
Drive Belt
Adjust drive belt tension.
Inspect
Suspension
Front suspension component boots and seals.
Fluid - M/T
Inspect fluid level.
Exhaust System
Coolant Line/Hose
Inspect coolant level, hoses and clamps.
Constant Velocity Joint Boot
Brake Hose/Line
Replace
Oil Filter, Engine
Engine Oil
If your mileage is less than 7,500 miles yearly, replace the engine oil filter at each oil change.
Rotate
Tires
Flush
Cooling System
Flush and replace engine coolant if it has been 30,000 miles or 24 months since the last change.
Drive Belt
Adjust drive belt tension.
Inspect
Suspension
Front suspension component boots and seals.
Fluid - M/T
Inspect fluid level.
Exhaust System
Coolant Line/Hose
Inspect coolant level, hoses and clamps.
Constant Velocity Joint Boot
Brake Hose/Line
Replace
Oil Filter, Engine
Engine Oil
If your mileage is less than 7,500 miles yearly, replace the engine oil filter at each oil change.
Rotate
Tires
Flush
Cooling System
Flush and replace engine coolant if it has been 30,000 miles or 24 months since the last change.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.