SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1995PICKUP R3500, 2D PICKUP, 8.0 W, RWD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONDTC INDEXCRUISE CONTROL SYSTEM DTCS
1995 Dodge and Ram Pickup R3500, 2D Pickup, 8.0 W, RWD, Automatic

Cruise Control System DTCS

1995 Dodge and Ram Pickup R3500, 2D Pickup, 8.0 W, RWD, AutomaticSECTION Cruise Control System DTCS
CRUISE CONTROL SYSTEM DTCS

OEM Code  Display On DRB  Description 
11 (Diesel Only) NO CRANK REFERENCE SIGNAL No Crank Reference Signal At PCM Detected During Engine Cranking
15 NO VEHICLE SPEED SIGNAL No Vehicle Distance (Speed) Sensor Signal Detected During Road Load Conditions
34 SPEED CONTROL SOLENOID CIRCUITS An Open Or Shorted Condition Detected In Speed Control Vacuum Or Vent Solenoid Circuits
34 SPEED CONTROL SWITCH ALWAYS LOW Speed Control Switch Input Below Minimum Acceptable Voltage
34 SPEED CONTROL SWITCH ALWAYS HIGH Speed Control Switch Input Above Maximum Acceptable Voltage
55 N/A Completion Of Fault Code Display On CHECK ENGINE Light
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.