Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1995PICKUP R3500, 2D PICKUP, 8.0 W, RWD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALSTARTERON-VEHICLE TESTINGSTARTER CONTROL CIRCUIT TESTRELAY TEST
1995 Dodge and Ram Pickup R3500, 2D Pickup, 8.0 W, RWD, Automatic
Relay Test
1995 Dodge and Ram Pickup R3500, 2D Pickup, 8.0 W, RWD, AutomaticSECTION Relay Test
- Relay is located in power distribution center. Remove relay. Using ohmmeter, check continuity between relay terminals No. 87A and 30. See Figure . Ensure continuity exists.
- Apply 12-volt source between terminals No. 85 and 86. Ensure continuity exists between terminals No. 30 and 87. Measure resistance between relay terminals No. 85 and 86. Resistance should be 70-80 ohms. Replace relay if it does not test as specified.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.