Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1992CARAVAN FWD V6-201 3.3LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTECHNICAL SERVICE BULLETINS
1992 Dodge and Ram Caravan FWD V6-201 3.3L
Computers and Control Systems: Technical Service Bulletins
1992 Dodge and Ram Caravan FWD V6-201 3.3LSECTION Technical Service Bulletins
- Customer Interest
- PCM - Cold Engine Knock
- A/T - 41TE/AE 42LE Delayed Gear Engagement
- PCM - Deceleration Shudder At Low Engine Speeds
- PCM - Engine Knock on Acceleration
- PCM - Rough Engine Idle After Cold Start
- BCM/Instruments/Warning Lamps - Inoperative
- Door Ajar Lamp - Flickers/Locks Cycle Repeatedly
- ECT Sensor - Hard/No Start In Low Ambient Temperatures
- By Symptom
- Customer Interest
- PCM - Cold Engine Knock
- A/T - 41TE/AE 42LE Delayed Gear Engagement
- PCM - Deceleration Shudder At Low Engine Speeds
- PCM - Engine Knock on Acceleration
- PCM - Rough Engine Idle After Cold Start
- BCM/Instruments/Warning Lamps - Inoperative
- Door Ajar Lamp - Flickers/Locks Cycle Repeatedly
- ECT Sensor - Hard/No Start In Low Ambient Temperatures
- Driveability
- Erratic Operation
- Inoperative
- No shift/Incorrect gear engagement
- Noise
- Customer Interest
- All Technical Service Bulletins
- A/C - Evaporator Freezes Up/Lack Of Cooling
- Engine Controls - Flash Programming Failure Recovery
- PCM - Cold Engine Knock
- Auto Computers - Y2K Effects
- Idle Air Control Motor - Whistling Noise
- A/T - 41TE/AE 42LE Delayed Gear Engagement
- PCM - Deceleration Shudder At Low Engine Speeds
- PCM - Engine Knock on Acceleration
- PCM - Rough Engine Idle After Cold Start
- BCM/Instruments/Warning Lamps - Inoperative
- Door Ajar Lamp - Flickers/Locks Cycle Repeatedly
- Transmission Range Sensor - Production Change
- ECT Sensor - Hard/No Start In Low Ambient Temperatures
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.