Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1983RAMPAGE L4-135 2.2LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMDISTRIBUTORSERVICE AND REPAIRFRONT WHEEL DRIVEDISTRIBUTOR ASSEMBLY
1983 Dodge and Ram Rampage L4-135 2.2L
Distributor Assembly
1983 Dodge and Ram Rampage L4-135 2.2LSECTION Distributor Assembly
4-135
1. Lubricate distributor housing bushings with engine oil, then install engine seal onto distributor housing.
2. Install distributor shaft thrust washer onto distributor shaft, then install shaft into distributor housing.
3. Install distributor drive gear thrust washer, then install distributor drive gear onto distributor shaft.
4. Install drive gear roll pin using punch.
5. Install Hall Effect Pickup Assembly.
6. Install Hall Effect Pickup Assembly retaining clips, then rotor and distributor cap.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.