Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1983RAMPAGE L4-135 2.2LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTEMISSION CONTROL SYSTEMSEXHAUST GAS RECIRCULATIONTESTING AND INSPECTIONCOMPONENT TESTINGTIME DELAY SYSTEM TEST TIMER
1983 Dodge and Ram Rampage L4-135 2.2L
Time Delay System Test Timer
1983 Dodge and Ram Rampage L4-135 2.2LSECTION Time Delay System Test Timer
1. Stop engine and then restart. Immediately open throttle to about 1000 RPM and observe EGR valve stem for movement.
2. If EGR valve moves within the first 30 seconds after starting, the EGR time delay system is defective.
3. Check hose connections to the time delay solenoid valve. Disconnect electrical plug from solenoid valve and energize valve by grounding either terminal and connecting other terminal to battery positive. If EGR valve stem now moves, the solenoid is defective and should be replaced. If EGR valve does not move, EGR valve timer may be defective, or there may be a problem in the wiring harness.
4. If control system is functioning properly, the valve and passages may be checked for exhaust gas flow. With engine at operating temperature and idling and with transmission in Neutral, apply 10 inches Hg vacuum directly to the EGR control valve. Idle speed should drop 150 RPM or more. This speed change confirms that exhaust gas is recirculating. If not, exhaust deposits in the EGR valve or intake manifold EGR passages are indicated.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.