Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1983RAMPAGE BASE, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 29 (SERVICING - A/T)ADJUSTMENTNEUTRAL SAFETY SWITCH
1983 Dodge and Ram Rampage Base, Automatic
Neutral Safety Switch
1983 Dodge and Ram Rampage Base, AutomaticSECTION Neutral Safety Switch
WARNING: This page is about a different car, the 1988 Plymouth Voyager, 1988 Plymouth Grand Voyager, 1988 Dodge Mini Ram Van, 1988 Dodge Grand Caravan, and 1988 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
- With transaxle linkage properly adjusted, switch should allow starter operation in "P" and "N" only. To test switch, remove wire connector and test for continuity between center pin of switch and transaxle case. Continuity should exist only when transaxle is in "P" or "N".
- Check for continuity between 2 outer pins. Continuity should exist with transaxle in "R" position only. There should be no continuity between either outside pin and the transaxle case.NOTE: Ensure gearshift linkage is properly adjusted before replacing a switch that tests bad.
- To replace, remove switch from case and allow fluid to drain. Move selector lever to "P" and "N" positions and check that switch operating fingers are centered in switch opening. Install new switch and seal. Tighten to 24 ft. lbs. (33 N.m). Retest switch for continuity and add transaxle fluid.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.