Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1983RAMPAGE BASE, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 25 (SERVICING - A/T)ADJUSTMENTSTRANSAXLE THROTTLE CABLEFWD MODELS
1983 Dodge and Ram Rampage Base, Automatic
FWD Models
1983 Dodge and Ram Rampage Base, AutomaticSECTION FWD Models
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 1989 Plymouth Sundance, 1989 Plymouth Reliant, 1989 Plymouth Horizon, 1989 Plymouth Acclaim, and 1989 Dodge Spirit. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure engine idle speed is correct and engine is at normal operating temperature. Loosen adjustment bracket lock screw. See Fig 1. Bracket must have both bracket alignment tabs touching transaxle cast surface. Tighten lock screw to 105 INCH lbs. (12 N.m).
- Release cross-lock on cable assembly by pulling upward. See Fig 1. To ensure correct adjustment, cable must be free to slide toward engine, against its stop, after cross-lock is released.
- Move transaxle throttle control lever fully clockwise against its internal stop. Press cross-lock downward into locked position.
- Move transaxle throttle lever counterclockwise. Slowly release it to ensure it will return to full clockwise position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.