Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1983RAMPAGE BASE, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 24 (SERVICING - A/T)ADJUSTMENTSKICKDOWN BAND (FRONT)
1983 Dodge and Ram Rampage Base, Automatic
KICKDOWN Band (Front)
1983 Dodge and Ram Rampage Base, AutomaticSECTION KICKDOWN Band (Front)
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 1988 Plymouth Sundance, 1988 Plymouth Reliant, 1988 Plymouth Horizon, 1988 Plymouth Caravelle, and 1988 Dodge Shadow. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Kickdown band adjusting screw is located on left side (top front) of transaxle case.
- Loosen adjusting screw lock nut, and back off 5 turns. After making sure adjusting screw turns freely in case, tighten screw to 72 INCH lbs. (8 N.m).
- Back off screw 2 1/2 turns. Hold adjusting screw in this position and tighten lock nut to 35 ft. lbs. (47 N.m.).KICKDOWN BAND ADJUSTMENT
Application Back Off Screw FWD Models 2 1/2 Turns
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.