Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1983RAMPAGE BASE, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 23 (SERVICING - A/T)ADJUSTMENTSTRANSMISSION THROTTLE CABLEFWD MODELS
1983 Dodge and Ram Rampage Base, Automatic
FWD Models
1983 Dodge and Ram Rampage Base, AutomaticSECTION FWD Models
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 1987 Plymouth Turismo, 1987 Plymouth Sundance, 1987 Plymouth Reliant, 1987 Plymouth Horizon, and 1987 Plymouth Caravelle. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure carburetor is not on fast idle cam (disconnect choke if necessary). Loosen adjustment bracket lock screw. Bracket must be free to slide on its slot for proper adjustment.
- Slide bracket to left (toward engine) to limit of its travel. Release bracket and move throttle lever fully to right, against its internal stop. Tighten adjusting bracket lock screw. This completes adjustment, as backlash was automatically removed.
- To check linkage freedom of operation, move transaxle throttle lever forward and slowly release. Ensure it returns to full rear position. See Fig 1 .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.