Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1983RAMPAGE BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESAXLE SHAFTSAXLE SHAFTS - FRONTSERVICE (IN-VEHICLE)INTERMEDIATE SHAFT ASSEMBLY (TURBO ONLY)REASSEMBLY (BEARING ASSEMBLY)
1983 Dodge and Ram Rampage Base, Automatic
Reassembly (Bearing Assembly)
1983 Dodge and Ram Rampage Base, AutomaticSECTION Reassembly (Bearing Assembly)
To install slinger, use a 2" (51 mm) diameter by 3" (76 mm) long pipe. Press bearing assembly onto shaft until there is a minimum 1/32" clearance between bearing and slinger.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.